Washer Repair: Most Common Washer Issues We See in DFW Homes

A shaking washer is one of the most common problems reported by our DFW customers. When the washer shakes too much during a spin cycle, it not only makes loud noises but can also damage the machine over time.

Why does it happen?

Uneven loads

Unbalanced washer legs

Worn-out suspension rods

How to prevent it?

Always distribute laundry evenly inside the drum. Make sure your washer sits flat on the floor. If shaking continues, call a washer repair expert to inspect internal parts.

Washer Repair for Drainage Issues

If your washer doesn’t drain properly, it could be due to clogged pipes or a broken drain pump. Drainage issues lead to standing water in your machine, making your laundry smelly and soggy.

Common causes:

Clogged lint filter

Kinked or blocked drain hose

Faulty drain pump

DIY Tip:

Check the hose and filter for blockages. If the problem persists, professional washer repair is recommended to avoid bigger damage.

Washing Machine Not Starting

Sometimes, your washer doesn’t even turn on. This can be frustrating, especially when you have a full laundry load ready.

Possible reasons:

• Power supply issues
• Faulty door latch
• Malfunctioning control panel

Solution:

Check the power outlet and plug. If those are fine, you’ll need a washer repair technician to look deeper into the issue.

Excessive Noise During Wash Cycles

Washer repair is often needed when loud noises start coming from your machine. Grinding, squealing, or banging noises aren’t normal and could indicate a serious problem.

What causes it?

• Worn-out bearings
• Loose drum
• Foreign objects stuck in the washer

Don’t ignore these sounds. Getting washer repair early can prevent expensive replacements later.

Washer Door Won’t Open

When the washing is finished, the door ought to open on its own. If it doesn’t, there could be a fault in the locking mechanism.

Common issues:

• Broken door lock
• Water not fully drained
• Error in the control system

Fix tip:

Unplug the washer and wait a few minutes. If the door still doesn’t open, washer repair service is your best option.

Water Leakage

Water leaking from your washer can lead to floor damage and even mold growth. This is a serious issue and needs quick attention.

Causes include:

• Damaged door seal
• Loose water inlet hoses
• Cracks in the drain hose

Get a washer repair expert to inspect the unit and seal any leak points immediately.

Detergent Not Dispensing Properly

When detergent stays in the drawer or doesn’t mix properly with water, your clothes may come out dirty even after washing.

Reasons:

• Blocked dispenser
• Low water pressure
• Faulty solenoid valve

Clean the drawer regularly and use only the right amount of detergent. For deeper issues, contact a washer repair professional.

Washer Smells Bad

Bad odors from the washer are common in humid areas like DFW. Mold and mildew build up inside the drum or rubber gasket.

Prevention tip:

Leave the washer door open after each wash to allow airflow. Once a month, run a vinegar cleaning cycle. If the smell continues, washer repair might be needed.

Spin Cycle Not Working Properly

A weak or non-working spin cycle means your clothes stay soaked after washing.

Likely causes:

• Worn-out motor
• Damaged belt
• Overloaded washer

Reduce laundry load size and avoid overstuffing the drum. If the issue repeats, go for a professional washer repair check.

Washer Displaying Error Codes

Modern washers display error codes when something goes wrong. These codes can point to problems with water levels, temperature, or internal sensors.

What to do?

Note the error code and refer to the user manual. If unclear, call an expert for a detailed washer repair inspection.